Body, workmanship, size, inspection standards:
• The horizontal error of cabinet products is required to be ±1.5mm after assembly, and the diagonal error is required to be between ±3mm. Spliced panel, flatness error allowed between ±0.4mm
• The units and parts of combined furniture such as combined cabinets and cabinets shall be smoothly connected, with continuous patterns and lines. The unit of combined furniture uses elbow, and the connecting part has decorative blocks (or strips).
• The joint of the product parts must be firm and tight, with the front joint gap not exceeding 0.2mm and the side joint gap not exceeding 0.2mm
• The cabinet of laminate (or horizontal board), the error is between ±1.5mm.
• Shrinkable drawer, door and cabinet body must have a uniform gap; The range is between 1.5mm and 2.4mm
Furniture surface treatment principles:
• In daily use, the parts that can be reached by skin and clothes must be smooth, without debris, burrs, nails and other protruding objects, and maintain a good touch sense.
• All parts that may be seen must be painted to meet the basic requirements of visual aesthetics.
• The coating effect is unified with the overall appearance style, showing comfort, warmth and confusion, nobility, luxury or nostalgia. Its texture, tone, transparency, gloss and wood grain are consistent with the original color plate, and the front side can clearly show the texture of precious veneer (also known as "bottom through").
• Turning and carved parts has obvious three-dimensional feeling, the bottom of the shovel is smooth, the transition is smooth, and there is no obvious knife marks and excess wood silk.
• After coating treatment of various surface materials, the performance effect of texture, color tone, transparency, gloss, antique damage and wood grain should be unified and coordinated. There must be no visible signs of artificiality. Archaize painting to natural, clear layers of light and dark, color transition is peaceful, can not appear multi-color.
Material standard
Wooden Materials:
• Dead joints, oil cores and bark are not allowed in any part. Dead knot judgment criteria: visible on both sides of the black knot, and can be cut off by the hand of the knot are called dead knot
• Force bearing parts (such as table foot, chair foot, stair pedal, bed foot) are not allowed to have dead joints, live joints, nor acceptable
• Joints parts (such as wooden dowel, perforation, installation of embedded nuts, etc.) are not allowed to have any knots
• Color difference should not be obvious, products should be color contrast during inspection (color palette as the standard)
• Wood moisture content should be below 16%
Painting and accessory requirements
• The color of the whole product or matching products should be similar
• The coating on the front face should feel smooth, without flow hanging, edge rising and bubbling
• The coating is flat and clear, the product at a distance of 50-80CM from eyes with no visible defects.
• Unpainted areas should be kept clean